443B101/443B102 28
Manual 19854 Rev. D
ECN 50523
Command: STAT
Purpose: Returns the settings of the 443B.
Response: The module responds with a string of the various settings delimited with
semicolons.
Command String: XYCOZSTAT
Description: X— Rack number of the target module (Range: ASCII printable characters, 0
through 3)
Y— Slot number of the target module. (Range: ASCII printable characters, 0
through 7)
C0Z— Module type for the target. Specifying "C01" in this argument addresses
a 443B101, specifying “C02” addresses a 443B102.
STAT— Commands the module to return its settings.
Response String: See next page.
Example: See end of response string definitions for example.
Response String: Mode; Output Sensitivity; Transducer Sensitivity; Low Frequency Response; Low
Pass Filter; Integration Units; Reference; Overvoltage; Fault (ICP mode only);
Zero Lock (long time constant charge mode only)
Description: Mode CHRG Charge mode.
ICP 0mA ICP mode with 0mA constant current (voltage mode).
ICP 2mA ICP mode with 2mA constant current.
ICP 4mA ICP mode with 4mA constant current.
ICP 8mA ICP mode with 8mA constant current.
ICP 12mA ICP mode with 12mA constant current.
ICP 20mA ICP mode with 20mA constant current.
Output
Sensitivity XX.XX mV/unit Output sensitivity without integration.
XX.XX mV/in/sec Output sensitivity with single integration
and English units.
XX.XX mV/mil Output sensitivity with double integration
and English units.
XX.XX mV/m/sec Output sensitivity with single integration
and SI units.
XX.XX mV/mm Output sensitivity with double integration
and SI units.
Transducer
Sensitivity XX.XX pC/unit Transducer sensitivity for a charge sensor
without integration.
XX.XX pC/g Transducer sensitivity for a charge sensor
To Next Page
Loading...