Features Setup Page
This page sets some of the parameters for peripheral devices
connected to the system.
AMIBIOS SETUP – FEATURES SETUP
(C) 2000 American Megatrends, Inc. All Rights Reserved
OnBoard FDC Enabled
OnBoard Serial Port 3F8h/COM1
OnBoard IR Port Disabled
OnBoard Parallel Port 378h
Parallel Port Mode ECP
Parallel Port IRQ 7
Parallel Port DMA 3
OnBoard PCI IDE Both
Audio Device Enabled
Modem Device Enabled
Ethernet Device Enabled
Onboard USB Function Enabled
USB Function for DOS Disabled
ThumbDrive for DOS Disabled
ESC : Quit ↑↓←→ : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift)F2 : Color
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
OnBoard FDC
Use this item to enable or disable the onboard
floppy disk drive interface.
OnBoard Serial
Port
Use these items to enable or disable the
onboard COM1 serial port, and to assign a
port address.
OnBoard IR Port
Use this item to enable or disable the onboard
infrared port, and to assign a port address.
Onboard Parallel
Port
Use this item to enable or disable the onboard
LPT1 parallel port, and to assign a port
address. The Auto setting will detect and
available address.
Parallel Port Mode
Use this item to set the parallel port mode.
You can select SPP (Standard Parallel Port),
ECP (Extended Capabilities Port), EPP
(Enhanced Parallel Port), or ECP + EPP.
Parallel Port IRQ
Use this item to assign either IRQ 5 or 7 to
the parallel port.
27
To Next Page
Loading...
