7
L510010-11
INTRODUCTION - 1
8. To insure prompt repair under this Warranty, Pleasurecraft will maintain a supply of warranted parts suffi cient
to meet the expected demand for such parts. Any replacement part may be used in the performance of any
warranty maintenance or repairs and will be provided by Pleasurecraft without charge to the owner.
9. Parts covered under this Warranty are:
1. Fuel Metering System
A. Fuel Injectors
B. Fuel Pressure Regulator
C. Manifold Absolute Pressure Sensor
D. Throttle Position Sensor
E. Throttle Body - Port Fuel Injection Models
F. Coolant Temperature Sensor
G. Intake Valves
H. Oxygen Sensors
2. Air Induction System
A. Intake Manifold
B. Air Filter (Flame Arrestor)
3. Ignition System
A. Spark Plugs
B. Electronic Ignition System
C. Ignition Coil and/or Control Module
D. Ignition Wires
10. Exclusions: The repair or replacement of any warranted part otherwise eligible for coverage under this
Warranty may be excluded from such warranty coverage if Pleasurecraft demonstrates that the engine and/
or part has been abused, neglected, or improperly maintained, and that such abuse, neglect, or improper
maintenance was the direct cause of the need for repair or replacement of the part.
11. Pleasurecraft original equipment parts are “identical in all material respects to that part as described in
the engine manufacturer’s application for certifi cation”. The use of any replacement parts not supplied by
Pleasurecraft may not meet this requirement and will be grounds for disallowing a claim made under this
Warranty. Pleasurecraft will not be liable under this Warranty or provide warranty coverage for product
failures caused by parts other than Pleasurecraft original equipment parts.
12. If you have any questions regarding your warranty rights and responsibilities, or the location of Pleasurecraft
warranty stations near you, you should contact Pleasurecraft at 1-803-345-0050.
4. Lubrication System
A. Oil Pump and Internal Parts
5. Positive Crankcase Ventilation (PVC) System
A. PCV Valve
B. Oil Filler Cap
6. Exhaust System
A. Exhaust Manifold(s)
B. Exhaust Riser(s)
C. Exhaust Valves
D. Catalytic Converters
7. Miscellaneous Items Used on Above Systems
A. Hoses, clamps, fi ttings, tubing, sealing
gaskets or devices and mounting hardware
B. Electronic Controls
C. Electronic Control Module
D. Pulleys, belts and idlers
To Next Page
Loading...
Need help?
General
