PCTV Systems Broadway 2T - Wired Setup - the Ethernet Mode

Setting up Broadway 2T
23
Wired Setup – the Ethernet Mode
ThisistheeasiestandfastestwaytosetupyourBroadway2Tandthenwatch
digitalTVinyourlocalnetwork.

WerecommendthisprocedurefortheinitialBroadway2Tsetup.

UsethissetupscenariowhentheTVsignalsourceandtherouterofyour
networkareinproximity.
E.g.yourDVB‐Tsigna
l
comesoutofanantennawall‐socketandyour
broadbandInternetconnectionisrightbesidetheantenna‐socket.Inthiscase
awiredconnectionbetweenBroadway2Tandrouterwouldbetheoptimum
solution.

Forasuccessfulinstallationfollowthesesteps:
1. ConnectBroadway2Ttoyourrou
terusinganEthernetcable
2. Connect
thepluggedinpowersupplyunittoBroadway2T
3. AccessBroadway2Tviaawebbrowser
4. FollowtheinstructionsoftheWizard
 connecttoantenna
 runachannelscan
5. WatchTV

Eachstepwillbeexplainedindetailinthefollowingchapters.

NotethatanInternetconnectionisstronglyrecommended.