7. When cleaning the product, use a soft, dry cloth. Do not use solvents or other chemicals.
FCC and IC NOTICE
This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment has very low levels of RF energy that are deemed to comply without
testing specific absorption ratio (SAR). This device complies with part 15 of the FCC rules. Operation is subject to the
following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
You are cautioned that any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/television technician for help.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the
device. This device complies with RSS-247 of Industry Canada. Operation is subject to the condition that this
device does not cause harmful interference. This Class B digital apparatus complies with Canadian ICES-003.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry Canada,. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent isotopically radiated power (e.i.r.p.) is
not more than that necessary for successful communication.
Hereby, Performance Designed Products declares that this remote control is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC. The declaration of conformity may be consulted
at www.pdp-eu.com/doc.
PDP Universal Media Remote for PlayStation 4 Instruction Manual – Download [optimized]
PDP Universal Media Remote for PlayStation 4 Instruction Manual – Download
Related Manuals
1. Playstation Bluetooth Media Remote Manual Media Remote for PS4™ Instruction Manual 051-075-NA LIMITED
WARRANTY Coverage...
2. PS4 Universal Media Remote Instructions Official Media Remote for Playstation 4 Instruction Manual 051-038-NA What...
3. PDP Products Warranty Information Product Warranty Information Performance Designed Products, LLC (“PDP”) warrants
to...
To Next Page
Loading...
