EasyManua.ls Logo

Peak Performance PKC0CT - Safety Warnings and First Aid; Explosive Gases and Battery Handling; First Aid Procedures

Peak Performance PKC0CT
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
3
GASES EXPLOSIVOS — No use este producto en presencia de vapores o gases
inflamables. El trabajar cerca de una batería de plomo-ácido puede causar que la
batería que se está cargando explote. Cuando las baterías de plomo-ácido están
cargando, ellas despiden gas de hidrógeno, el cual puede ser encendido por chispas
de conexiones eléctricas. Es importante leer este manual antes de cargar la batería
y siga exactamente las instrucciones de carga de la batería cada vez que use el
Cargador de Baterías.
No fume o use artículos inflamables (fósforos, encendedores de cigarrillos, etc.) mientras trabaja •
en el sistema de batería de un vehículo.
Nunca cargue una batería congelada, ya que puede explotar.•
No exponga la batería al fuego o al calor intenso, ya que puede explotar. •
Antes de reciclar o desechar la batería, proteja los terminales descubiertos con cinta aislante •
eléctrica para evitar cortocircuitos (cortocircuitos puede resultar en heridas corporales o en un
incendio).
Cuando use este producto, siempre use gafas para proteger los ojos. El contacto con el ácido de •
la batería podrá causar ceguera y/o quemaduras químicas severas.
Siga estos procedimientos de primeros auxilios en caso de contacto accidental con ácido de •
batería.
PROCEDIMIENTOS DE PRIMEROS AUXILIOS
PIEL: Lávese completamente la piel si el ácido de la batería hizo contacto con la piel.
Obtenga inmediatamente atención médica.
OJOS: Enjuáguese los ojos con agua fría durante por lo menos diez minutos. Obtenga
inmediatamente atención médica.
SI SE INGIERE, PÓNGASE INMEDIATAMENTE EN CONTACTO CON UN CENTRO DE
CONTROL DE ENVENENAMIENTO.
Nunca toque las pinzas del cargador entre sí o contra un pedazo de metal común. Podrá resultar •
en chispas, explosión o daños a la unidad. Después de usarlas, siempre almacene las pinzas en
el porta pinzas apropiado ubicado en la parte trasera de la unidad.
Asegúrese de que le cordón de energía CA esté desconectado del tomacorriente CA antes de •
conectar o desconectar las pinzas del cargador.
Coloque esta unidad tan lejos de la batería que se está cargando como lo permitan los cables de •
carga.
Nunca coloque el Cargador de Baterías encima de la batería que está siendo cargada; los gases •
de la batería oxidarán y dañarán el Cargador de Baterías.
Nunca permita que el ácido de la batería gotee sobre el Cargador de Baterías al probar o llenar la •
batería.
Nunca coloque una batería sobre el Cargador de Baterías.•
Cuando use el Cargador de Baterías cerca de la batería y del motor del vehículo, coloque la •
unidad sobre una superficie plana y estable, mantenga todas las pinzas, cordones, ropa y partes
del cuerpo alejados de las piezas en movimiento del vehículo.
Siga estas instrucciones y aquellas publicadas por el fabricante de la batería y por el fabricante de •
cualquier equipo que usted intente usar cerca de la batería. Antes de cargar, préstele atención a
las precauciones de peligro en estos productos y en el motor.
Este sistema fue diseñado para ser usado sólo en vehículos con sistema de batería de 12 voltios •
CC. NO LO CONECTE a un sistema de batería de 6 ó 24 voltios.
Un cordón de extensión no deberá ser usado a menos que sea absolutamente necesario. El uso •
de un cordón de extensión inapropiado podrá resultar en un riego de incendio y electrochoque. Si
se tiene que usar un cordón de extensión, asegúrese de:
Que los pines del enchufe del cordón de extensión tengan el mismo número, tamaño y
forma que los del Cargador de Baterías.
Que el cordón de extensión esté alambrado apropiadamente y en buenas condiciones.
Que el calibre del cable sea AWG #18 (calibre 18) para dimensiones de hasta 100 pies
(30,48 m) o AWG #16 (calibre 16) para distancias mayores de 100 pies.
Que usted conecte el Cargador de Baterías al cordón de extensión antes de enchufar el
cordón de extensión en una toma de corriente de 110/120 voltios CA.
Quítese todas las joyas y objetos metálicos que pudieran causar cortocircuitos o reaccionar •
con el ácido de la batería. Una batería de plomo-ácido produce una corriente de cortocircuito
suficientemente alta como para soldar un anillo u otro objeto similar al metal, causando una
quemadura severa.
3
EXPLOSIVE GASES — Do not use this product in the presence of flammable fumes
or gases. Working in the vicinity of a lead-acid battery can cause an explosion of the
battery being charged. When lead-acid batteries are charging, they vent explosive
hydrogen gas which can be ignited by sparks from electrical connections. It is
important to read this manual before charging and follow the battery charging
instructions exactly each time you use this Battery Charger.
Do not smoke or use flammable items (matches, cigarette lighters, etc.) while working on a •
vehicle’s battery system.
Never charge a frozen battery, as it could explode.•
Do not expose battery to fire or intense heat, as it can explode. •
Before recycling or disposing of a battery, protect exposed terminals with heavy-duty electrical tape •
to prevent shorting (shorting can result in personal injury or fire).
Always wear protective eyewear when using this product. Contact with battery acid can cause •
blindness and/or severe chemical burns.
Follow these first aid procedures in case of accidental contact with battery acid.•
FIRST AID PROCEDURES
SKIN: Wash skin thoroughly if battery acid comes in contact with skin. Seek medical
attention immediately.
EYES: Flush eyes with cool water for at least ten minutes. Seek medical attention
immediately.
CONTACT POISON CONTROL CENTER IMMEDIATELY IF INGESTED.
Never touch charger clamps together or to a common piece of metal. Sparking, explosion or •
damage to the unit can result. Always store the charger clamps in the appropriate storage area on
the back of the unit after use.
Ensure the AC power cord is disconnected from AC power before connecting or disconnecting •
charger clamps.
Place this unit as far away from the battery being charged as the charging cables will permit.•
Never place Battery Charger directly above battery being charged; gases from battery will corrode •
and damage Battery Charger.
Never allow battery acid to drip on Battery Charger when testing or filling battery. •
Never set a battery on top of Battery Charger.•
When using the Battery Charger close to the vehicle’s battery and engine, place the unit on a flat, •
stable surface, and keep all clamps, cords, clothing and body parts away from moving parts of the
vehicle.
Follow these instructions and those published by the battery manufacturer and manufacturer of •
any equipment you intend to use near the battery. Pay attention to all hazard precautions on these
products and on the engine before charging.
This system is designed to be used only on vehicles with a 12-volt DC battery system. DO • NOT
connect to a 6-volt or 24-volt battery system.
A• n extension cord should not be used unless absolutely necessary. Use of an improper extension
cord could result in a risk of fire and electric shock. If extension cord must be used, make sure:
That pins on plug of extension cord are the same number, size and shape as those of plug
on Battery Charger.
That extension cord is properly wired and in good electrical condition.
That wire size is AWG #18 (18 gauge) for up to 100 feet; AWG #16 (16 gauge) for
distances over 100 feet.
You connect the Battery Charger to the extension cord before plugging the extension cord
into a 110/120-volt AC power outlet.
Remove all jewelry or metal objects that could cause short circuits or react with battery acid. A •
lead-acid battery produces a short circuit current high enough to weld a ring or other similar
objects to metal, causing a severe burn.
When working on electrical equipment, always ensure someone is nearby to help you in an •
emergency.
Do not operate Battery Charger with damaged cord or plug – replace the cord or plug immediately.•
NEVER alter an AC cord or plug. If the plug will not fit the outlet, have a proper outlet installed •
by a qualified electrician. Improper connection can result in a risk of electric shock. The Battery
Charger is for use on a nominal 120-volt AC circuit.
Do not operate Battery Charger if it has received a sharp blow, been dropped or otherwise •
damaged in any way; take it to a qualified serviceman.
All manuals and user guides at all-guides.com

Related product manuals