Peak PLIN-USB - Page 10

1. Select LIN hardware.
The installed hardware is displayed.
2. Click on PLIN-USB.
The view expands and the current ID is displayed in an input field.
3. Enter a hexadecimal number with suffix “h” as the new Device ID.
4. Confirm the entry with Set.
3.3.1 Identifikation
If you have connected several PLIN-USB interfaces you can identify a single
interface via PEAKSettings.
1. Select LIN hardware.
The installed hardware is displayed.
2. Click on PLIN-USB.
The view expands and the Identify button is displayed.
3. Click on Identify.
The LED of the selected PLIN-USB flashes orange for five seconds.
3 Operation PLIN-USB
User Manual 2.1.0 © 2023 PEAK-System Technik GmbH
10