Peak PLIN-USB - Operating the PLIN-USB

3 Operation
3.1 Status LED
LED status Meaning
Green on There's a connection to a driver of the operating system.
Green slow blinking
The LIN interface is initialized with a valid bitrate. A software application
is connected to the LIN interface.
Green quick blinking Data is transmitted via the connected LIN bus.
3.2 Unplugging the USB Connection
The LIN interface can be disconnected from the computer without further actions.
In Windows, the LIN interface is not listed under "Safely Remove Hardware".
3.3 Distinguishing several PLIN-USB
You can operate several PLIN-USB interfaces on a single computer at the same
time. For this purpose, the device ID can be determined in order to distinguish the
LINinterfaces in a software environment.
PLIN-View Pro
To set the device ID in PLIN-View Pro:
1. Open the tab PLIN-USB.
2. Enter a hexadecimal number with suffix “h” as the new hardware ID.
3. Confirm the entry with Set.
PEAK Settings
To set the device ID in PEAK Settings:
3 Operation PLIN-USB
User Manual 2.1.0 © 2023 PEAK-System Technik GmbH
9