Peak PLIN-USB - Page 14

4. If the bit rate is known: Select the bit rate of the LIN bus from the Bit rate list.
If the bit rate is unknown: Determine the bit rate under Bit rate detection with
Detect.
Note: The LIN interface must not be initialized by any other software.
Bit rate detection as master. Bit rate detection as slave.
5. Confirm the settings with OK.
6. Optional: To initialize another channel or LIN interface, open another instance of
PLIN-ViewPro.
4 LIN Monitor PLIN-View Pro PLIN-USB
User Manual 2.1.0 © 2023 PEAK-System Technik GmbH
14