6.5.3. Manually zeroing Current Meter Offset
The power supply will auto-zeroing the current meter offset when powered up. In case it is
needed to reset current meter to zero during test and you do not want to restart power supply.
You can manually reset it to zero in menu mode.
Press and hold Voltage Control Knob for 30s to enter MENU mode. It shows
Rotate Current Control Knob until the Current meter showing
Then press Current Control Knob once to confirm. The “YES” will be lighted after successful
zeroing current meter offset.
Finally, press Voltage Control Knob to exit MENU mode.
6.6 Remote Control Mode
To control the output voltage and current by remote control connector (10)
-42-
To Next Page
Loading...
