Size = A5
ENGLISH
26
USB mode
1. Insert an USB Stick with MP3/WMA
music fi les.
2. Press on the product or SOURCE
on the remote control to call up the
USB mode.
3. Playback starts automatically and the
fi rst track will be played. If there is no
USB device connected, the message
NO USB device found will be dis-
played on the screen.
Note
Connect the USB device directly to the
USB port of the unit. Using an extension
cable is not recommended and may cause
interference and failure of data transfer.
This product supports USB 1.1 and 2.0 up
to 32GB with fi le system FAT16 and FAT32.
CD/USB Playback
1. Start or pause the playback: Press the
button. In pause mode the track
numbers will fl ash on the display.
2. Stop playback: Press the
button. In
stop mode the total number of tracks
will appear on the display.
3. Skip to next track: Press the but-
ton. Press and hold for fast forward.
4. Skip to previous track: Press the
button. Press and hold for fast back-
ward.
5. During playback, press REP repeat-
edly to switch the playback modes as
follow
Press Display Result
1x OFF Normal Playback
2x REP ONE Repeat one track
3x
REP
FOLD
Repeat album
(only for MP3)
4x REP ALL Repeat all tracks
5x SHUFFLE Play a track randomly
Notes:
• This product reads CD, CD-R/-RW and
MP3-CD discs. Other discs are not sup-
ported.
• When playing CD-R/RW discs the play-
back quality might be infl uenced by the
quality of the burned disc. When burn-
ing CD-R/RW disks with audio fi les we
recommend using the slowest burning
speed.
Program playback CD/USB
Notes:
• Up to 20 CD tracks or up to 99 MP3
tracks can be programmed for a play-
back in any desired order.
• Programmed playback can only be made
from one single source - it cannot include
tracks from CD disc and USB storage at
the same time.
1. Stop playback: Press the
button
2. Enter program settings: Press the
PROG button. “P01” fl ashes on the
display.
3. Select desired track: Press
or .
4. Save selected track into program
memory: Press again the PROG but-
ton. “P02” fl ashes on the display.
5. Repeat step 3 and 4 to program ad-
ditional tracks.
6. After programming all the desired
tracks, press button to start the
program playback.
7. Stop playback: Press 1x button.
8. Cancel program playback: Press 2x
button.
IM_PMS310BT-B_170920_A_V03_HR.indb 26 20/9/17 10:33 am
To Next Page
Loading...