Pearson OpScan iNSIGHT 70 - Chapter 4 Scanner Checkout; Overview; Scanner Checkout Procedures; System Software

4-1
Chapter 4
Scanner Checkout
Overview
This chapter discusses the procedures for scanner checkout, pre-installed system
software, system verification and backup, and customer hand-off.
Scanner Checkout Procedures
To checkout the OpScan iNSIGHT 70 scanner, refer to the following sections in
the Maintenance Manual for the OpScan iNSIGHT™ 70 Scanner:
• Hopper and Stacker Operational Checkout (Section 2.6)
• Sensor Checkout Procedures (Section 2.8)
• Read Station Adjustments (Section 3.2)
• Check Alignment (Section 5.2.4.8)
• Hopper Height Adjustments (Section 3.5)
• Pick Area Adjustments (Section 3.3)
• Calibrating (and Normalizing) the Scanner (Section E.2)
System Software
OpScan iNSIGHT 70 scanner system software, ScanTools
®
Plus, is pre-installed at
Pearson NCS. For information regarding this software, refer to the ScanTools
®
Plus User’s Guide. This guide includes information on installation, setup, and
configuration. Error messages are not documented in this publication. For
information on the error messages, refer to the online help.