v
Preface
About This Manual
This manual describes how to set up and install the Pearson NCS OpScan
iNSIGHT 70 scanner. This manual does not document how to install and
configure the OpScan iNSIGHT 70 system software. OpScan iNSIGHT 70 scanner
system software is pre-installed and configured at Pearson NCS.
The scanner is typically used with a computer, a color monitor, a printer, and can
be connected to a server as part of a scanning network system.
This guide is intended for use by Pearson NCS-trained field engineers. It is
assumed that the field engineers have had some training or experience in
computer setup and installation, scanners and scanning technology, and
networks.
For information on operating the scanner, refer to the Operator's Guide for the
OpScan iNSIGHT™ 70 Scanner.
Contents of the Manual
Chapter 1 provides an overview of the OpScan iNSIGHT 70 scanner's features
and parts.
Chapter 2 describes the process of unpacking and positioning the system
components, setting up, and installing the OpScan iNSIGHT 70 scanner.
Chapter 3 provides information on installing the scanner computer and other
peripherals.
Chapter 4 provides information on scanner checkout procedures, system
software, system verification, and customer hand-off.
Note: Depending on when you purchased your OpScan iNSIGHT 70 scanning system, you
are most likely running Windows XP
®
as the operating system on your host computer.
However, because of the possibility of different operating systems, this manual will
reference the operating systems generically as the “Windows” operating system.
To Next Page
Loading...