FRONT PANEL
,J;d"
.'f>r)((~(:t
, (717111Iip'<:1
POWER
DESIGNED AND MADE IN USA
STANDBY
POWER SWITCH (1)
Depress the switch to the "On" position. The red pilot light (LED) will illuminate indicating power is being supplied to the
unit.
POWER LED (2)
Illuminates when AC power is being supplied to the amp.
STANDBY SWITCH
(3)
Allows amp to be placed in standby or
active
mode. In standby mode the tubes remain hot, but the amplifier is not
operational.
STANDBY LED
(4)
Illuminates when amp is on. Does not illuminate when on standby.
REAR PANEL
6
9
SPEAKER
SPEAKER
LINE OUT
UNEOUl
INPUT
INPUT
14
'-OUTPUTS--OUTPUTS-
rr:
;
--
2 '-..-- 1
--,'-
1
2
3©'
3©'
4 5 6
4
5
6
®
®
3@7
3©'
2 8
2 8 2 8 2 8
1 9 1 9 1 9 1 9
0 10
0
10
0
10
0
10
1S OHM MIN
160HM MIN
LEVEL LEVEL SENSITIVITY SENSITIVITY
® ®
®
7®
®10i)
OUT
lOUT
UNBALANCED UNBALANCED
80HMiviiN
80rlMMIN
...--DIRECT O,UT
DIRECT OUT
2
®
~
@
@
® ®
4 OHM MIN
40HMMIN
eooc
coon
60WRMS31VRMS 60WRMS31VRMS
TRAN. BAL fRAN. BAL.
GNO
I
o
,
,
WARNING
TO PREVENT THE RISK OF FIRE AND SHOCK HAZARD. DO NOT
EXPOSE THIS APPLIANCE TO RAIN
REMOVE COVER. NO
REFER
PREVENT THE RISK OF FIRE AND SHOCK
WITH SAME TYPE 250 VOLT FUSE
AVIS: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
REIviPLACER PAR UN FUSIBLE DE MEME TYPE ET DE 250 VOLTS
120 VAC
60 Hz.
400 WATTS
FUSE
5AMP
A PRODUCT OF PEAVEY ELECTRONICS CORP
MERIDIAN. MS MADE If>,;U.S.A
5
8
SPEAKER OUTPUTS (5)
Speaker output
(%")
jacks are provided 16, 8, and 4 ohms. When the 16 and 8 ohm jacks are engaged, the amp produces full
power into 8 ohms. When all three jacks are engaged, the amp produces full power into 4 ohms
LINE OUTPUT LEVEL (6)
Controls the signal
level
at the line output jack. This control may be used as a balance control when
slave
power
amp/speaker systems are driven from the line output.
LINE OUTPUT (7)
The line output provides a signal with
level
control to drive other power amplifier/slave speaker systems. (See Line Output
Level)
DIRECT OUT
(8)
Provides 600 ohm, transformer balanced signal to be used as "direct" patch into mixing consoles, tape recorders, etc. The
signal at this point has been frequency compensated for low noise operation.
To Next Page
Loading...
