Peavey Delta Blues - Specifications; Power Amplifier Section; Rated Power & Load; Power @ Clipping

SPECIFICATIONS
POWER AMPLIFIER
SECTION
4 - 6BQYEL84’s with 12AX7
driver
Rated Power & Load:
30 W RMS into 16 or 8 ohms
Power @ Clipping: (Typically)
(5% THD, 1 kHz, 120 V AC line)
30 W RMS into 16 or 8 ohms
(Bias must be reduced to measure)
Frequency Response:
+0, -2 dB, 50 Hz to 15 kHz,
@ 20 W RMS into 16 ohms
Hum & Noise:
Greater than 80 dB below rated
power
Power Consumption:
150 watts, 50/60 Hz, 120 V AC
(Domestic)
PREAMP SECTION
2 - 12AX7’s
The following specs are mea-
sured @ 1 kHz with the con-
trols preset as follows:
Pre & Post (lead) @ 0
Reverb Level @ 0
Bass & Treble EQ @ 12
Middle EQ @ 0
Channel Select Out
Boost Switch Out
Nominal level is with Input
Gain @ 6
Minimum level is with Input
Gain @ 12
Preamp Normal Input:
Impedance: Very high Z,
470 K ohms
Lead Channel:
(Post Gain @ 12)
Nominal Input Level: -40 dBV,
10mVRMS
Minimum Input Level: -70 dBV,
0.3 mV RMS
Normal Channel:
Nominal Input Level: - 17 dBV,
140 mV RMS
R
v -
F.S.
Minimum Input Level: -28 dBV,
40 mV RMS
Maximum Input Level: 0 dBV,
1.0 V RMS
Equalization:
(Lead & Normal Channels)
Custom bass, middle & treble
passive type EQ
Effects Send:
Load Impedance: 1 K ohm
or greater
Nominal Output Level: -6 dBV,
0.5 V RMS
Effects Return:
Impedance: High Z, 2 M ohms
Designed Input Level: -6 dBV,
0.5 V RMS (Switching jack
provides Effects Send to Effects
Return connection when not
used)
External Footswitch Function:
Normal/Lead Channel Select
(when Lead activated)
Tremolo Defeat
6