Need help?Do you have a question about the Peavey EQ 31 and is the answer not in the manual?
General| Brand | Peavey |
|---|---|
| Model | EQ 31 |
| Category | Stereo Equalizer |
| Language | English |
Describes the signal path and functions shown in the block diagram.
Details the 31-band 1/3 octave filters and their capabilities.
Regulates overall gain, allowing signal loss recovery.
High pass filter adjustable from 10 Hz to 300 Hz.
Low pass filter adjustable from 4 kHz to 35 kHz.
Bypasses EQ controls, routing input directly to output.
Selects +/-6 dB or +/-12 dB cut/boost range.
Turns the unit on, indicated by a red LED.
A three-pin female XLR jack for balanced input termination.
Uses ½" jacks for unbalanced or stereo inputs.
Transformer balanced male XLR output for line balancing.
Two paralleled ½" phone jacks for unbalanced output.
Details typical performance characteristics like frequency response and distortion.
Specifies maximum and nominal input/output levels and impedance.
Lists filter frequencies, Q, bandwidth, and cut/boost ranges.
To Next Page
