Need help?Do you have a question about the Peavey EQ 31FX and is the answer not in the manual?
General| Type | Graphic Equalizer |
|---|---|
| Frequency Range | 20 Hz - 20 kHz |
| Input Connectors | XLR, 1/4" TRS |
| Output Connectors | XLR, 1/4" TRS |
| Signal to Noise Ratio | >95 dB |
| Power Supply | Internal |
| Power Requirements | 100-240V AC, 50/60 Hz |
| Frequency Bands | 31 Bands |
| EQ Range | ±12dB |
| Input Impedance | 20 kOhms balanced |
Guidance on room equalization, feedback control, and system tone adjustment.
Introduction to the front panel controls and indicators of the equalizer.
Detailed explanations of Low Cut, High Cut, LED Meter, Gain, EQ Section, and Feedback LEDs.
Introduction to the rear panel, including power switch and input XLR.
Specifics on 1/4" jacks, line cord, and power requirements for domestic/export.
Illustrates a mono send connection from mixer to EQ and power amplifier.
Explains the one-year, 90-day warranties and conditions for validity.
Instructions for obtaining service and the importance of warranty registration.
Essential safety rules including water, heat, ventilation, cord handling, and servicing.
Warnings about high noise levels and recommended hearing protection measures.
To Next Page
