Need help?Do you have a question about the Peavey PV 231EQ and is the answer not in the manual?
General| Number of Channels | 2 |
|---|---|
| Frequency Bands | 31 |
| Bandwidth | 1/3 octave |
| Frequency Range | 20 Hz to 20 kHz |
| Signal to Noise Ratio | > 90 dB |
| Range | ±12 dB |
| Boost/Cut Range | ±12 dB |
| Bypass Switch | Yes |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Power Supply | Internal |
| Type | Stereo Equalizer |
| Frequency Response | 20 Hz to 20 kHz |
| Input Connectors | XLR, 1/4 inch TRS |
| Output Connectors | XLR, 1/4 inch TRS |
| Low Cut Filter | 40Hz |
| Input Impedance | 10 kΩ |
This LED array indicates signal level from -10 dB to +17 dB.
Regulates overall gain of the equalizer section, compensating for signal loss.
Adjusts filter rejecting frequencies below the selected point.
Adjusts filter rejecting frequencies above the selected point.
Controls adjust cut or boost at respective frequencies.
Allows signal to bypass all features except the low-cut filter.
Selects boost/cut range (+/-12 dB or +/-6 dB) for finer control.
Applies mains power to the unit; adjacent LED indicates activation.
Standard IEC power connector including fuse holder.
Lifts circuit ground while keeping mains safety ground intact to reduce hum.
Male 3-pin connectors for balanced output.
Female 3-pin connectors for balanced input.
Covers defects in material/workmanship for products purchased/serviced in U.S.A./Canada.
Details what is not covered, such as accidental damage or unauthorized repairs.
This warranty protects only the original retail purchaser of the product.
Specifies warranty period based on product category.
Peavey will repair or replace covered products at no charge for labor or materials.
Instructions on how to get warranty service via dealer or service center.
Limits duration of implied warranties like merchantability and fitness for purpose.
Limits Peavey's liability for damages to repair/replacement of defective product.
To Next Page
