Peavey IPA 150T - Product Description and Features; Unit Description; Key Features Overview; Front Panel Controls

FEATURES
POWER OUTPUT:
• 150 Watts RMS into 4 ohms
CONTROLS AND INDICATORS:
• Level control
• Subsonic filter switch
• Power on LED
• Power switch
OUTPUTS:
• 4 ohm screw terminal direct output
• 8 ohm balanced output
• 25 volt balanced output
• 70 volt balanced output
• 1V/600 ohm balanced output
• AC convenience outlet
spaces.
WARNING!
DO NOT ATTEMPT TO INSTALL THIS UNIT WHILE IT, OR
ANY CONNECTING UNITS, ARE POWERED ON. RISK OF
ELECTRICAL SHOCK EXISTS IF ALL UNITS ARE NOT
POWERED OFF DURING INSTALLATION. TO PREVENT
ELECTRICAL SHOCK OR FIRE HAZARD, DO NOT EX¬
POSE THIS APPLIANCE TO RAIN OR MOISTURE.
DESCRIPTION:
The I PA ™ 150T is a high performance utility amplifier
designed to meet the needs of the most demanding fixed
installation/PA application. The convenient patch panel
layout, coupled with state of the art circuit design assures
reliable long-term operation and smooth trouble-free instal¬
lation.
Twenty five and seventy volt fully isolated line output
capability is standard equipment. The I PA 150T has been
packaged for standard 19" “rack-mount” capability with
optional rack-mount kit, and occupies only two vertical rack
LEVEL (1)
Controls the volume level of the system.
SUBSONIC FILTER (2)
The “in” position of this switch activates the 18 dB/octave
subsonic filter at 42 Hz. The “out” position removes the sub¬
sonic filter from the system.
POWER ON LED (3)
Indicates when AC power is being supplied to the unit.
POWER SWITCH (4)
Depress to “on” position to turn on.
5 6 7 8
A DIVTSfON OFPCAVEY ELECT9CWCS CORP
BALANCED MASTER
INPUT ' —) fVOL.i
LCZi &€> LOZ2 1 2
II 1 1 Ut^S WITCHED
■ ■ ■ 120 VAC 60 Hz
| M 1 VOW MAX
1 - I NPUTS - 1
1- I NPUTS — 1
(7\
5 AMP
150 W RMS
GMJ XFMR COM 8Li 25V 70V
BALANCED (1V400U}
GND_ LQ m Hf _
12C VAC
GO Hi
40C WATTS
245/ 35V