Need help?Do you have a question about the Peavey IPR2 5000 and is the answer not in the manual?
Covers essential safety guidelines for electrical product usage, including handling and installation.
Warns about potential permanent hearing loss from high noise levels and recommends protection.
Lists key features and specifications of the IPR2™ 5000/7500 power amplifiers.
Specifies minimum clearance for proper airflow to prevent overheating.
Describes the function and illumination of the amplifier's power switch.
Explains the function of LED indicators: Active, Signal, DDT, Temp, and DC.
Explains the function of input attenuator controls for gain adjustment.
Controls High Pass, Full Range, and Low Pass filter settings for channels.
Describes the 1/4" jacks for patching signals to other amplifiers or inputs.
Details XLR and 1/4" input connectors and their balanced nature.
Explains the 4-pole twist lock output connectors for speaker connection.
Explains the function of the circuit breaker and reset procedure.
Details the IEC power connector, voltage, and grounding safety.
Specific wiring instructions for UK mains plugs and terminals.
Lists key features of the DSP-based Loudspeaker Management System.
Details front panel controls (Power, Attenuators) and LED indicators (Active, Signal, DDT, Temp, DC) for DSP models.
Details XLR/1/4" inputs, Thru/Out jacks, and 4-pole speaker outputs for DSP models.
Explains circuit breaker function, AC power inlet, voltage, and grounding for DSP units.
Specific wiring instructions for UK mains plugs on DSP models.
Lists main menu options: Input Mode, Volume, Crossover, EQ, Delay, Limiting, Memory, Lock.
Describes how to navigate, select, edit, save, and exit DSP menus and parameters.
Options to discard edits or save and exit Sub Menus.
Adjusts channel volume and configures input mode (Stereo/Mono).
Saves and applies input mode settings before returning to the main menu.
Allows inverting output polarity for phase alignment and driver alignment.
Enables bypassing EQ channels and setting EQ for individual channels.
Adjusts bass enhancement and configures five bands of parametric EQ per channel.
Applies a 6dB/octave high frequency boost for high frequency horns.
Configures channel delays for driver alignment and system alignment (meters/feet).
Sets limit threshold to control signal level and prevent clipping.
Stores and recalls up to four user-defined presets with custom names.
Explains how to save and recall settings to/from memory locations.
Enables locking controls to prevent unauthorized adjustment with password protection.
Details what is covered and what is excluded under the Peavey warranty.
Outlines warranty duration, protection scope, and how to obtain service.
Limits implied warranties and excludes certain types of damages.
To Next Page
General
