IPR-3000 DSP Specification Sheet
Rated Power (2 x 2 ohms) - 1,450 watts per channel @ 1 kHz 1% T.H.D. both channels driven.
Rated Power (2 x 4 ohms) - 815 watts per channel @ 1 kHz at <0.1% T.H.D. both channels driven.
Rated Power (2 x 8 ohms) - 430 watts per channel @ 1 kHz at <0.1% T.H.D. both channels driven.
Rated Power (1 x 2 ohms) - 1,590 watts @ 1 kHz at <0.1% T.H.D.
Rated Power (1 x 4 ohms) - 910 watts @ 1 kHz at <0.1% T.H.D.
Rated Power (1 x 8 ohms) - 450 watts @ 1 kHz at <0.1% T.H.D.
Minimum Load Impedance - 2 ohms
Maximum RMS Voltage Swing - 67 volts
Frequency Response - 10 Hz - 22 kHz, +/- 0.5 dB at 1 watt.
T.H.D. (2 x 2 ohms) - <0.1% @ 1,300 watts per channel from 20 Hz to 3 kHz, decreasing to 1,120 watts at 20 kHz.
T.H.D. (2 x 4 ohms) - <0.1% @ 800 watts per channel from 20 Hz to 20 kHz.
T.H.D. (2 x 8 ohms) - <0.1% @ 420 watts per channel from 20 Hz to 20 kHz.
Input CMRR - > - 76 dB @ 1 kHz
Voltage Gain - x 47 (+33.4dB)
Crossover - Adjustable frequencies with 24dB/oct, 4
th
order Linkwitz –Riley High Pass and Low Pass filter per channel
Crosstalk - > -68 dB @ 1 kHz at 400 watts power @ 8 ohms.
Hum and Noise - > -92 dB, "A" weighted referenced to rated power @ 4 ohms.
Slew Rate - > 12V/μs
Damping Factor (8 ohms) - > 225:1 @ 20 Hz - 1 kHz at 8 ohms
Input Sensitivity - 1.215 volts +/- 3% for 1 kHz 4 ohm rated power, 1.195 volts +/- 3% for 1 kHz. 2 ohm rated power.
Input Impedance - 15k ohms, balanced and 7.5k ohms unbalanced.
Current Draw @ 1/8 - 917 watts @ 2 ohms, 618 watts @ 4 ohms, 353 watts @ 8 ohms.
Current Draw @ 1/3 - 2,016 watts @ 2 ohms, 1,236 watts @ 4 ohms, 662 watts @ 8 ohms.
Cooling - Temperature dependent variable speed 80 mm DC fan.
Controls - 2 front panel detented attenuators, push-button navigation encoder to navigate through the menus on the
LCD screen for input mode, parametric EQ, crossover H.P.F, Normal, L.P.F. and more.
Indicator LEDs - 2 DDT (clip limiting), 2 Signal presence, 2 Active status, 2 Temp and 2 DC protect.
Protection - Thermal, DC, subsonic, incorrect loads, under and over voltage.
Connectors - Inputs: Dual Combi 1/4” & XLR, Outputs: Dual 1/4” signal patch, dual 4-pin twist-locking connectors.
Construction - 0.062” thick aluminum.
Dimensions - 3.5”x19”x 10.5” behind front panel + 0.6” for handle
Net Weight - 3.40 kg (7.5 lbs.*)
Gross Weight - 4.54 kg (10 lbs.)
Warranty - 5 years
Rated power readings made with BW: <10 Hz to 22 kHz. All power measurements made at 120 VAC and 240VAC.
2 ohm power is time limited by circuit breaker.
*Net Weight does not include power cord.
To Next Page
Loading...
