Peavey Max 100 - Rear Panel Connections; TUNE;MUTE Switch; POWER SWITCH; AC POWER INLET

Rear Panel
(13) TUNE/MUTE (not available on Max 208)
Pressing this button will engage the chromatic tuner while muting the output to the speaker. e LED screen will indicate which note
is being played while the red and green LEDs above the screen indicate whether the note is at (red), sharp (red) or in tune (green).
is switch also mutes the DI.
(14) POWER SWITCH
15
16
23
21
19
1817
20
22
(15) AC POWER INLET:
is is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this connector to provide
power to the unit. Damage to the equipment may result if improper line voltage is used. (See line voltage marking on unit).
Never break o the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a suitable
grounding adapter should be used, and the third wire should be grounded properly. To prevent the risk of shock or re hazard, always
make sure that the amplier and all associated equipment is properly grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals
in your plug, proceed as follows: (1) e wire that is colored green and yellow must be connected to the terminal that is marked by
the letter E, or by the Earth symbol, or colored green or green and yellow. (2) e wire that is colored blue must be connected to the
terminal that is marked with the letter N, or the color black. (3) e wire that is colored brown must be connected to the terminal that
is marked with the letter L, or the color red.
(16) LINE VOLTAGE SELECT SWITCH
is selector switch allows the amplier to be operated at dierent line voltages. Please be sure this switch is set to the
proper voltage for your area before connecting the amplier to a power source or turning the amplier on for the rst time.
NEVER CHANGE THE POSITION OF THIS SWITCH WHILE THE AMPLIFIER IS TURNED ON.
CAUTION! THE FUSE MUST BE CHANGED TO THE CORRECT VALUE PRINTED ON THE REAR OF THE CHASSIS IF
A DIFFERENT LINE VOLTAGE IS SELECTED.
(17) SPEAKER OUTPUT JACK (Max 150, 250, and 300 only)
is combination 1/4" / twist-lock connector is used to connect a speaker cable to the amplier. e minimum load impedance on the
amplier is 8Ω.
(18) FOOTSWITCH JACK
e optional footswitch (part number 03022910) plugs into this jack. e footswitch controls OVERDRIVE and MUTE.
(19) HEADPHONE OUTPUT
1/8" headphone output for personal monitoring.
(20) AUX INPUT
is 1/8" input jack allows you to connect a CD player or MP3 player to your MAX® Series bass amp and play along