Peavey PA 700S - Page 10

SPE
Re
Peavey Electronics, Corp.
TAL A Street
Meridian, Missi
ippi 39301
Frequency Response:
20.0 Hz — 20.0 kHz + 2.0 dB € 130 Watts r.m.s. Output
Total Harmonic Distortion:
0.15% THD 20 Hz — 20 kHz © 130 Watts r.m.s. Output
Equivalent Input Noise:
Low Z input, -123 dBV @ 150 Ohms (0.7 uV}
High Z input, -80 dB below 2.0 V r.m.s. @ 20.0 dB gain
Crosstalk:
-50.0 dB @ 1.0 kHz (between A and B outputs)
-70.0 dB @ 1.0 kHz (between monitor and effects outputs)
Inputs:
Low impedance unbalanced microphone 600 Ohm (cannon plug)
High impedance unbalanced line 50.0 k Ohm (% inch phone plug)
Input Attenuator:
Continuously variable gain from O dB to -40 dB
Used on both line and microphone inputs
Mixer Gain
60.0 dB with graphic equalizers in flat position
Outputs:
A and B power outs —130 Watts r.m.s. Z = 4.0 Ohms
A and B Main and Monitor:
Unbalanced 5.0 V r.m.s. into 10.0 k Ohms, 2.0 V r.m.s. into 600 Ohms
(+8.0 dBm)
Effects High:
Unbalanced, 2.0 Volts r.m.s. into 10.0 K Ohms
Effects Low:
Unbalanced, 0.20 Volts r.m.s. into 10.0 K Ohms
Graphic Equalizer Outputs:
Unbalanced, 4.0 Volts r.m
into 600 Ohms
Inputs:
Power Amp input for mamixum output: 1.20 Volts r.m.s.
Effects Return Level — Control Maximum
0.15 Vr.m.s.
Aux Inputs:
Monitor — 2.50 V r.m.s.
Effects —2.50 V r.m.s.
Graphic Equalizer:
All sliders adjusted to indicated flat response — 4.0 Volts r.m.s.
Effects Return: Control Maximum
0.50 Volts r.m.s.
Equalization — Channel:
Infinitely variable boost and cut, + 15.0 dB € 100.0 Hz and 5.0 kHz each channel
Equalization — Graphic Equalizers:
Infinitely variable boost and cut, + 12.0 dB at 9 frequencies
Specifications and features printed in this manual are subject to change without notice