Peavey PA 700S - Page 5

The MAIN OUT (D) (E) jacks are designed to allow the addition of power amplifiers as required by the
user. The nominal output impedance is 600 Ohms with a typical level of 1.0 Volt r.m.s.
The two MONITOR OUTPUT (F) (G) jacks are unbalanced with a nominal output impedance of 600
Ohms
and
are
capable
of
approximately
2.0
Volts
r.m.s.
output.
These
jacks
are
connected
in
parallel.
The EFFECTS HIGH OUTPUT (H) is capable of 2.0 Volts r.m.s. into 10.0 k Ohms and can be used
to drive an additional power amplifier and speaker system from the effects buss to obtain an additional
monitor send.
The EFFECTS LOW OUTPUT (|) is a lower level signal than the effects high and is intended to drive
the input of an effects devise such as an echo unit, phasor, etc. It is capable of 0.4 Volts r.m.s. into 10.0
k Ohms.
The REVERB FOOTSWITCH JACK (J) is used with an accessory footswitch to enable the operator
to defeat the reverb function of the mixer from a remote position.
The MONITOR AUXILIARY INPUT (K) is an input to the monitor mixing busses to be used when
patching another mixer to the PA 7005. These inputs can be used whenever an additional input is required
to the monitor buss.
The MAIN AUXILIARY INPUTS A and B (N) are inputs to the main A and B mixing busses of the
PA 700S. These inputs are used when patching another mixer to the PA 700S or any time a signal source
is to be placed on the monitor mixing buss.
The EFFECTS AUXILIARY INPUT (L) is the input to the effects mixing buss of the PA 7008. This
input mixes a signal with the effects buss at the same point as the individual channels and is to be used
when patching two mixers together or anytime access is needed to the effects mixing buss.
The EFFECTS RETURN JACK (M) is where the signal returning from an effects device patches into
the PA 700S.
The
POWER
SWITCH
is
the
type
that
enables
the
operator
to
easily
reverse
the
polarity
of
the
line
or
mains
cable.
This
is
provided
to
minimize
buzz
by
proper
polarization
of
the
AC
power
supply
(mains)
connection.
SPECIAL NOTE. Some export versions of the PA 7008 do not have the two-way switch and the
preceding information should be disregarded for these models.
A HEAVY-DUTY POWER (MAINS) CABLE is provided for durability under road conditions. This
is
a
three
wire
approved
cord,
and
it
is
NOT
advisable
to
remove
the
ground
pin
under
ANY
circumstances.
If
you
should
find
it
necessary
to
operate
the
system
where
the
proper
three
wire
receptacles
are
not
available, you should use a three-to-two wire adaptor.