To Next PageTo Next Page
Need help?Do you have a question about the Peavey PR 15 and is the answer not in the manual?
General| Sensitivity | 98 dB |
|---|---|
| Impedance | 8 Ohms |
| Woofer Size | 15 inches |
| Tweeter | 1.4 inches |
| Grille | Steel with foam backing |
| Input Connectors | 1/4" and Speakon |
Specifies the speaker's nominal electrical resistance, rated at 8 Ohms.
Details the speaker's input connectors, featuring two 1/4" phone jacks wired in parallel.
Describes the enclosure construction: injection-molded 1/4" thick polypropylene with textured dark gray finish.
Lists the speaker's physical dimensions (H x W x D) and its total weight.
Outlines mounting options: molded-in stand-mount cup and flying point inserts.
Details the speaker drivers: 15" woofer and 1.4" titanium diaphragm compression driver.
Specifies the driver protection mechanism, utilizing a positive temperature coefficient resistor.
Indicates the speaker's directivity, with a coverage pattern of 90° x 40°.
Highlights primary features including two-way design, power handling, crossover, and horn type.
Advises consulting a structural engineer for suspension and warns against improper rigging.
Provides instructions for using all four suspension inserts and limiting enclosure angle from vertical.
Specifies correct bolt diameter (1/4" x 20) and recommends grade 5 bolts for mounting.
Warns against transporting the cabinet while mounted on brackets to prevent undue stress.
Limits bolt penetration to 1/2" beyond the surface to prevent damage to mounting inserts.
Shows the PR 15 input plate with power, impedance, and warning information.
Includes warnings regarding potential hearing damage from high loudness and suspension dangers.
Provides Peavey Electronics Corporation contact details and copyright information.
