Need help?Do you have a question about the Peavey PVXp 10 and is the answer not in the manual?
General| Woofer Size | 10 inches |
|---|---|
| HF Driver Size | 1.4 inches |
| Frequency Response | 50 Hz - 20 kHz |
| Outputs | XLR |
| Enclosure Material | Polypropylene |
| Inputs | XLR, 1/4" TRS |
| Dimensions | 23.5 x 14.5 x 13.5 inches |
Details the various uses of the PVXp 10 Bluetooth speaker system.
How to replace the AC power line fuse for overload protection.
How to connect AC power and operate the power switch for unit operation.
Details on input jacks, level controls, MIC/LINE switch, and the output jack.
Information on indicators, DSP controls, LCD screen, and important safety warnings.
Critical warnings on input connections, grilles, hearing, and speaker suspension safety.
Details on M8 insert groups and specifications for mounting hardware.
Warning on bolt depth and instructions for AC power connection and permanent installation.
Guidelines for mounting, stands, and connecting audio signals.
Recommends balanced cables and provides a detailed guide for adjusting input sensitivity and gain.
Explains DSP functions, LED indicators, and details on the 1/8" AUX input.
How to interpret LCD level bars and safely disconnect AC power.
How to access DSP menus and adjust the Master Gain level.
Adjusting Master Gain and accessing EQ/HPF for Channel 1.
Adjusting the High and Mid EQ bands for Channel 1 by +/- 6 dB.
Adjusting the Mid and Low EQ bands for Channel 1 by +/- 6 dB.
Adjusting Low EQ and configuring the High Pass Filter for Channel 1.
How to exit channel settings and return to the main DSP menu screen.
Accessing CH2 settings and the main system parameter menu.
Selecting EQ presets (Normal, Live, Club, Speech) for the speaker system.
Information on the Live and Club Mode EQ presets.
Details on Speech Mode and selecting location settings.
Specifics of the Bracket location setting for nominal wall placement.
Details on Pole and Monitor location settings for optimal response.
Warning against adding external bass boost EQ to avoid overload.
Adjusting system signal delay from 0 to 33 feet (10 meters).
Choosing between Mix Out and Link Out for the output jack.
Further details on output parameters and overview of Bluetooth controls.
Accessing the Bluetooth menu and selecting App Control settings.
Settings for App Control 'On', 'Off', and 'Secondary' for linked configurations.
Enabling streaming and basic steps for linking speakers.
Linking parameters, speaker roles, and setup for streaming/app control.
Setting auto link and connecting via Bluetooth streaming and app control.
Information on Bluetooth range and overview of the Config menu.
Settings for Display Dim, Auto Link, and Front LED status.
Turning the front LED on/off and setting it to indicate compression/limiting.
Understanding the limit LED and accessing the About menu.
Displaying model/firmware info and confirming factory reset.
Performing a factory reset and steps to resolve no sound output.
Diagnosing and fixing hum/buzz and distorted audio problems.
Troubleshooting input/EQ, avoiding heat, and cleaning procedures.
Applying touch-up, checking hardware, and overview of architectural/engineering specs.
Physical dimensions, weight, and power requirements of the system.
Details on crossover, connections, enclosure, mounting, and amplifier power ratings.
Specs for input impedance, sensitivity, DSP, frequency response, and noise.
To Next Page
