Loudspeaker System Specifications
21
Fig. 17 CH2 Selections
Similarly, you can reach CH3, the adjustments for the Gain and EQ controls for
the Bluetooth® signal source, and push in the "Push for DSP" knob to access
these channel settings. As noted above, this channel does not have any HPF or
adjustments for same.
PARAMETERS MENU
From the Main Start Screen, Fig. 1, if you push in the "Push for DSP" knob
instead of rotating it, a menu screen comes up that allows for adjustment of the
following speaker system parameters:
MODE
LOCATION
DELAY
OUTPUT
See Fig. 18
Fig. 18 Parameters Menu
Mode selects the speaker system EQ Preset.
Location selects the physical location of the speaker with respect to physical
boundaries.
Delay selects how long the input signal is delayed before it is output as sound.
Output selects the mode of the Output jack, Mix or Thru
Turning the "Push for DSP" knob one click CW highlights the Mode parameter,
push in the "Push for DSP" knob, and the parameter is selected.
See Fig. 19
To Next Page
Loading...
