points, two sets on the top, two sets on the bottom, and one single insert on the rear near the bottom, with a total
of 13 cabinet inserts, provide for the ultimate in installation exibility. A pair of black powder coated perforated
steel grilles provides driver protection and a professional appearance.
e heavy-duty 10” woofer has a 2 3/8” voice coil diameter, and a 50 oz. magnet for chest-pounding bass. e
RX™10 compression driver tweeter is coupled to a Quadratic roat™ constant directivity waveguide. e Qua-
dratic roat Waveguide™ is an original Peavey® design, with smooth, even response, low distortion and good
high frequency dispersion. is horn has an asymmetrical vertical polar response, aiming the main energy lobe
down 10 degrees, so it is aimed at the audience, instead of over their heads. e vertical polar pattern is +20
degrees, -40 degrees. is helps reduce ceiling reections for greater clarity and gain before feedback.
e PVX™p 10 Bluetooth® speaker system power ampliers providing the bi-amplication are low-distortion
reliable fan-cooled units providing a total of 520W peak dynamic power for the system.
ere is 400W peak dynamic power for the woofer, and 120W peak dynamic power for the tweeter. e power
supply for both amps is a switch mode type for low weight and high eciency. Both ampliers feature sophis-
ticated DSP based signal compression, which virtually eliminates audible power amplier clipping. Cooling is
provided via a low-noise fan, for reliable operation under any conditions.
Input for two of the three input channels is via a combo female XLR and 1/4” TRS phone jack with balanced
input to the preamp/EQ electronics, and a level control. For these two channels, a switch is provided to change
between line level gain and mic level gain. A third channel is for a Bluetooth® source, or alternatively a 1/8” AUX
input jack. Each channel has an adjustable Level control knob, and also a three-band EQ section that is accessi-
ble via the DSP menu Push knob. ere is a balanced output, a Male XLR, that can feed the mixed signals from
the three channels out to another component. is output allows linking of additional speaker systems, or feed
of the signal to a powered subwoofer, etc.
e cabinet of the PVX™p 10 Bluetooth® speaker system has multiple mounting y points, providing outstanding
versatility in permanent install use. A pair of widely spaced M8 inserts is molded-in on the top, and a pair on
the bottom, and a set of four M8 inserts is available on the top, on the bottom for use with the Versamount™ 70,
and one M8 on the rear near the bottom. is is a total of 13 mounting inserts in all. All of these inserts have
retaining hardware on the inside of the plastic cabinet, providing a more reliable and safe mode of mounting the
cabinet.
Applications
e Peavey PVX™p 10 Bluetooth® has a variety of applications such as sound reinforcement, public address, side
ll system, karaoke or musical playback.
e multiple y points make use as a permanent install system very convenient with lots of installation exibility.
A typical signal source for the line-level inputs of the Peavey PVX™p 10 Bluetooth® would be a sound reinforce-
ment mixing console (mixer) or the output from a CD player, MP3 player or tape deck. e Bluetooth® link
provides for many modern devices to link to the system, such as smart phones, digital mixers, etc. A typical
dynamic microphone can be connected directly via the XLR input and used as well.
To Next Page
Loading...
Need help?
General
