Peavey PVXp 10

Loudspeaker System Specifications
31
Auto Link
If it is desired that the PVX™p speakers link all of the time as part of a
permanent setup, the two speakers can be set to automatically link every time
they are turned on.
 On each PVX™p speaker (Primary and Secondary), navigate to
the "Config" screen. See the Config Menu section below this
section.
 Change the "Auto Link" setting from "Off" to "On".
Fig. 43 Fig. 44
To stop the Auto Link feature, simply turn it back to "Off" on each
speaker.
Bluetooth Connection Instructions:
Streaming Audio
 On the PVX™p speaker, navigate to the Bluetooth® screen (BT
header and subsequent menu, Fig. 33, 34)
 Set Streaming to "On"
 The PVX™p speaker's Bluetooth® LED (8) will start blinking
 On your Bluetooth® device, navigate to Bluetooth® settings
 Select PVXp speaker
 The Bluetooth® device should change from "Not Connected" to
"Connected"
 Once connected, the PVX™p speaker Bluetooth LED (8) will light
solid.
App Control
 In the Bluetooth® App Control menu, change the PVX™p
speaker's "App Control" from "Off" to "On".
 Open the App on your Bluetooth® device. The speaker should
connect automatically.
 The PVX™p speaker Bluetooth® LED (8) will light solid.
 The connected speaker will be listed at the top of the App in the
Device list.