Peavey Rage 108 - System Design and Specifications; Block Diagram; Amplifier Specifications; Preamp Specifications

BLOCK DIAGRAM
SUPER GAIN
AMP
LEAD
SWITCH
LOGIC
SUPERSAT®
INPUT
NORMAL
LEVEL
PREANP
our
4 OHM
SPEAKER
HEADPHONE
This block diagram shows signal flow within the unit In order to thoroughly understand the unit's functions, please study the block diagram carefully.
RAGE® 108
SPECIFICATIONS
POWER AMPLIFIER SECTION:
RATED POWER & LOAD
12W RMS into 4 ohms
POWER @ CLIPPING: (Typically)
(10% THD, 1 kHz, 120V AC line)
12W RMS into 4 ohms
TOTAL HARMONIC DISTORTION
Less than 0.5%, 100mW to TW RMS.
60 Hz to 10 kHz, 4 ohms (Typically
below 0.2%)
POWER CONSUNPTION
30W. 50/60 Hz, 120V AC
HEADPHONE OUTPUT:
Load impedance: 4 ohms or greater
Nominal power output: 20 mW into
4ohms
(Stereo jack, monaural signal,
disconnects internal speaker when
phone plug is inserted)
SYSTEM HUM & NOISE @ NOMINAL
INPUT LEVEL:
(20 Hz to 20 kHz unweighted)
72 dB below rated power
PREAMP SECTION:
The following specs are measured @
2 kHz with the controls preset as follows:
Channel Select Normal (Ou!)
Low & High @ 10
Mid @ 0
Supersat3"a Post Gain @ 10
Nominal Levels are with Normal Gain
es
Minimum Levels are with Normal Gain
a
PREAMP INPUT
Impedance: High Z, 220K ohms
Nominal Input Level: -10 dBV,
300 mV RMS
Minimum Input Level: -26 dBV,
50 mV AMS
Maximum Input Level: 0 dBV, 1V RMS
PREAMP OUTPUT
Load Impedance: 10K ohms or greater
Nominal Output Level:
-6 dBV, 0.5V RMS
WARNING
EQUALIZATION:
TO
PREVENT
ELECTRICAL
SHOCK
OR
FIRE
HAZARD,
DO
NOT
EXPOSE
Special
low.
mid
&
high
passive
THIS
APPLIANCE
TO
RAIN
OR
MOISTURE.
BEFORE
USING
THIS
ae
$
APPLIANCE,
READ
BACK
COVER
FOR
FURTHER
WARNINGS.
"Built under U.S. Patent # 4,811,401