Peavey Ultraverb II - Page 26

Appendix: Ultraverb II Specifications
Frequency Response
Dry signal: 20 Hz - 20 kHz
Effect signal: 20 Hz -15 kHz
Number of Programs
300 Factory preset patches
300 User-programmable patches
Resolution
16-bit linear PCM
Maximum Delay Range (either channel)
0.0-2.00 seconds
Signal to Noise Ratio
Dry signal: 100 dB minimum
Effect signal: 96 dB minimum
Recommended Input Level (either input)
-20 dBv minimum, +10 dBv maximum
Nominal Output Level
+6 dBv maximum
Headroom
Active: 20 dB down from maximum
Limit: 6 dB down from maximum
Chorus LFO Modulation
Rate: 0.1 Hz -10 Hz
Depth: 0% -100%
Waveshape: Sine wave
MIDI
Modes: Poly/Omni/Off
Real time control signal recognized: Note number, velocity, pressure, pitch
wheel, continuous controllers 1-120 (32 and 96-101 omitted)
Controllable parameters: 1 per patch
System exclusive: Dump or load by bank, or all