Peavey Ultraverb II - Page 4

1.1C Power jack
Plug the output of the AC adapter supplied with the Ultraverb II into the
16VAC power jack. Do not use any other adapter—this may damage your
unit and void the warranty .
The Ultraverb II has no on-off switch. Plug the AC adapter transformer and
your other gear into a switched barrier strip so that turning off the barrier
strip turns off all power.
1.1D Setting Levels
For the best signal-to-noise ratio, turn up the Input Level control so that the
Clip/Signal LED is green most of the time. An occasional red flash is
acceptable, but consistent flashing means you should turn down the Input
Level. Effect Mix varies the blend of dry (full counterclockwise) and
processed (full clockwise) signals; set halfway for a 50-50 mix. Set Output
Level as required to interface with the rest of your system.
1.1E Typical Hookup 1: Guitar Amplifier with Optional MIDI
Footswitch
Ultraverb II
MIDI in
m m
stereo loop
return jacks
MIDI out
MIDI Footswitch/Control Pedal
stereo locp
send jacks
The Ultra verb II plugs into the stereo effects loop of a guitar amp. If the loop
level is adjustable, it should be set to line level (not guitar level). If the loop
is mono, plug the loop send into the Ultraverb II left/mono jack, and patch
either Ultraverb II output into the loop return jack. Set the Ultraverb II's