Peavey Ultraverb II - Page 8

2.2A Select MIDI Channel
CH Selects the MIDI channel over which the Ultraverb II will receive MIDI
commands. Use + and - to select a channel from 1 to 16, or scroll past 16 to
select o (Omni; receives messages appearing on any of the 16 MIDI
channels).
2.2B Program Change Response
PC Determines whether the Ultraverb II will respond to program change
messages. Press + for yes (responds to changes), - for no (ignores changes).
2.2C Convert MIDI Out to MIDI Thru
EC The MIDI out can "echo" data appearing at the MIDI in, thus turning
the MIDI out into a MIDI thru. Press + to echo data, - to leave MIDI out as
out only.
Note
Ultraverb II system exclusive messages that appear at MIDI in (from, for
example, a sys ex librarian or other Ultraverb II) will not be echoed.
2.2D Dump User Patch Data Via MIDI System Exclusive Messages
db Patch information can be dumped as MIDI system exclusive data
through the MIDI out jack, and captured by a MIDI system exclusive storage
device such as the Peavey MIDI Streamer, DPM 3, DPM SE, etc. Since this
data can later be loaded back into the Ultraverb II, system exclusive dumps
are a convenient way to back up the internal user patches to guard against
loss, or build up a library of custom patches.
To dump patch information as sys ex:
1. Connect the Ultraverb II MTDI out to the system exclusive storage device's
MIDI in.
2. Set up the storage device to receive MIDI data (refer to the particular piece
of equipment's manual). Make sure it is set to the same MIDI channel as the
Ultraverb II (if the Ultraverb 11 is set to Omni, set the storage device to
channel 1).
3. Choose which patches to dump with the + and - buttons, as shown in the
display: