Need help?Do you have a question about the Peavey VMP 2 and is the answer not in the manual?
General| Type | Tube Microphone Preamplifier |
|---|---|
| Channels | 2 |
| Tubes | Yes |
| Output Impedance | 600 Ohms |
| Frequency Response | 20 Hz - 20 kHz |
| Inputs | XLR |
| Outputs | XLR |
| THD | < 0.1% |
| Power Supply | External Power Supply |
| Phantom Power | +48V |
| Controls | Gain, phase reverse, phantom power |
| Tube Complement | 12AX7 |
Controls the main power for the unit. The red pilot light illuminates when power is supplied.
Illuminates when AC power is being supplied to the unit.
For use with high impedance microphones or high level sources via 1/4" plug.
Varies the gain of the channel input stage for a wide input dynamic range.
Active tone control (shelving type, +/-10 dB) for the high frequency range.
Active tone control (shelving type, +/-10 dB) for the low frequency range.
Decreases the gain of the XLR balanced input by 20 dB.
Selects 48 V DC phantom power for its channel.
Used to defeat the channel EQ section.
Activates a 12 dB/octave low cut filter at 40 Hz or 80 Hz.
For low impedance microphones or low level sources with an XLR connector.
XLR transformer balanced output connectors.
1/4" unbalanced output connectors.
Covers placement, ventilation, heat sources, power supply, cords, and cleaning.
Details OSHA permissible noise levels and recommends hearing protection.
To Next Page