Peavey VYPYR PRO - VYPYR PRO Quick Start Guide; Initial Setup and Operation Guide; Preset and Effect Adjustment Procedures

A. Plug and Play
•Turn power/standby switches to “On” position.
•Plug in instrument.
•Selecting Presets–Use knob on far right of panel.
•Use outer bank wheel (1) to scroll through preset banks. Each bank contains up to four presets.
•Use inner knob (2) to nd a preset. Press inner knob to select the preset.
B. Adjusting Presets
•Mode Select
•Push mode select button (3).
•Scroll(4) through Model Types (i.e. Stomp Box, instrument, eect or amp)
and press knob (4).
•Select modes for up to 4 models.
•Press Model Knob to select mode(e.g. Amp, Eect etc...)
•Scroll through amp models, for example, and press the knob to select.
•With the model selected, that parameter knobs (5) will illuminate. You are now playing through
that eect or amp.
•Adjust Model Parameters–applicable parameter knobs (5) will illuminate.
• Press model you want to edit.
• e parameter knobs will illuminate to reect that model’s settings.
• Edit chosen model.
• e Vypyr Pro will remember your changes even if you change models until you save the preset
• Delay/Reverb Quick Edit Menu
• Tap the Delay/Reverb Edit button (6)
•Use the parameter knobs to edit the basic Delay and Reverb functions.
•Use the Deep Edit menu described below for more editing options.
•Delay/Reverb Deep Edit Menu
•Press and hold “Delay/Reverb edit” (6).
•Select reverb or delay (model 2 or 3). Scroll through styles using bank wheel (1)
(e.g. spring reverb or tape delay).
•Press inner button (2) to select delay or reverb type.
•Applicable parameter knobs will illuminate. Select parameters.
•Tap tempo – Use tap tempo button (7) to adjust delay intervals.
•To exit simply press “Delay/Reverb edit” button.
•Once Delay and Reverb Types are selected per preset, simply pressing the Delay/Reverb edit
button (6) will select the delay and reverb quick edit functions, which operate just like the previ-
ous Vypyrs.
NOTE: e Deep Edit Menu is also where input and output parameter settings can be adjusted, such as
noise gate control, loop level, boost level, resonance, presence and preset master volume.
VYPYR® PRO Quick Start