Peavey Vypyr VIP 2


HIGH ENCODEr
HIGH ENCODEr
High EQ adjustment. High EQ adjustment. In edit mode this In edit mode this knob controls the Lknob controls the Level or amount of Devel or amount of Delay effect. elay effect. All the way to All the way to thethe
left is zero and all the way to the right is max.left is zero and all the way to the right is max.
pOSt GaINpOSt GaIN
This is the individual preset volume. In Edit mode this knob controls the amount of Reverb.This is the individual preset volume. In Edit mode this knob controls the amount of Reverb.
maStEr VOLumEmaStEr VOLumE
Turn it up, ours goes to 13!Turn it up, ours goes to 13!
pOWEr SpONGEpOWEr SpONGE
This knob allows you to reduce the powThis knob allows you to reduce the power output of the amplifier. er output of the amplifier. Don’t confuse this with the MDon’t confuse this with the Masteraster
Volume control. Volume control. Power Sponge adjusts the amount of power the amp Power Sponge adjusts the amount of power the amp is capable of producing. This is capable of producing. This circuitcircuit
allows you to get that full on cranked sound at bedroom levels. The Power Sponge can adjust the maximumallows you to get that full on cranked sound at bedroom levels. The Power Sponge can adjust the maximum
output of the power amp from 100 Watts all the way down to 1 Watt.output of the power amp from 100 Watts all the way down to 1 Watt.
LOOpEr INDICatOrLOOpEr INDICatOr
This function requires a SanperaThis function requires a Sanpera
®®
I or Sanpera II foot controllerI or Sanpera II foot controller. . Waste no time in making that Waste no time in making that purchase—purchase—
the looper will allow you hours and hours of fun. the looper will allow you hours and hours of fun. You You can record any 30 plus seconds of anything, can record any 30 plus seconds of anything, switchswitch
your tone (preset), and play over top of your ryour tone (preset), and play over top of your recording. ecording. For example, try recording a bass trFor example, try recording a bass track, thenack, then
change your tone to a lead tone and play over the top! Note the LED that corresponds to the looper on thechange your tone to a lead tone and play over the top! Note the LED that corresponds to the looper on the
encoder will turn on when recording or playing back the loop.encoder will turn on when recording or playing back the loop.
EDIt mODEEDIt mODE
Edit mode simply changes the 5 amp controls to their alternate function as listed on the bottom of theEdit mode simply changes the 5 amp controls to their alternate function as listed on the bottom of the
encoder. encoder. When in Edit mode the Edit mode LED will either be green if When in Edit mode the Edit mode LED will either be green if you are editing Effects, or red if you are editing Effects, or red if youyou
are editing Stompboxes. are editing Stompboxes. TTo enter Edit mode simply press either the Stompbox encoder (Item 2) o enter Edit mode simply press either the Stompbox encoder (Item 2) or theor the
Effects encoder (Item 4). Effects encoder (Item 4). TTo exit Edit mode simply press the same encoder again.o exit Edit mode simply press the same encoder again.
VIVIp p 3 F3 Foon n ppnenell
88
99
1010
1111
1212
1313
11
2 2 3 3 44
00
1212