Q1： What kind of battery is used in E2400 LFP? How long it can last?
A： E2400 LFP utilizes high quality UL certified automotive LiFePO4 battery, it can retain 80% of its original capacity at
3500 complete charge cycles.
Q2： What devices can E2400 LFP power?
A： Please note that the AC output port can only charge or power devices that operate at less than 2400W.
DC output port can only charge or power that operate at less than 12V-30A.
Q3： Can the E2400 LFP be used as UPS?
A： E2400 LFP supports UPS function with an automatic switchover time of 8~20ms.
Q4： How to calculate the E2400 LFP running time?
A： Running Time=Total Capacity(2048Wh) * 0.85(Depth of Discharge)/Loading Power(Watts)
Q5： Does E2400 LFP have built-in MPPT charge controller?
A： Yes, there are two independent built-in MPPT charge controllers; “5521”port supports 12~18V(Max 100W) PV
input, and “GX16MF”port supports 32~95V(Max 700W) PV input.
Q6： Can the E2400 LFP be charged while discharging?
A： Yes, It can be charged and discharged at the same time. In the non-UPS state, if uninterrupted use is required, the
average power of charging must be greater than the average power of electricity, otherwise the battery will
eventually run out and shut down.
Q7： How to store the E2400 LFP?
A： Please turn off the unit and then store it in a dry, ventilated place at normal room temperature. Do not place this
unit near water sources or a wet/moist environment. For long-term storage, it is recommended to discharge the
battery to 30% every three months and recharge it to 60% to sustain the battery life.
Q8：Other issues to be noted.
A：Pay attention to the ponit that the product is without waterproof function and prevent water getting into it.
Pay attention to ventilation and heat dissipation when using, and keep good ventilation at the air inlet and outlet of
the product.
Do not use the product in special occasions (under the mine, gas station, etc.)
FAQS
support@pecron.com
To Next Page
Loading...
