support@pecron.com
1、 Do not place the device near heat source, such as a fire or a heating furnace.
2、 Do not immerse in any liquid, or expose the unit to rain or wet conditions.
3、 Do not use the battery in a strong static electricity or electromagnetic environment.
4、 Do not disassemble or puncture the product with sharp objects in any way.
Please read the user manual thoroughly before using this product, and keep this manual in a safe place for future
reference. Failure to follow the instructions for proper set up, use, and care for the device can increase the risk of serious
personal injury, death, or property damage. Once you use this device, you are deemed to have understood, recognized
and accepted all terms and contents of this document. The user shall be responsible for his own actions and all
consequences arising from failure to use the device in accordance with the “User Manual”, or as authorized in PECRON's
current product literature.
In compliance with laws and regulations, PECRON reserves all rights for final explanation, and to change these terms and
conditions at any time without prior notice. In the event that any revisions are made, the revised terms and conditions
shall be posted on our website immediately, please visit our website to inform yourself of any changes.
DISCLAIMER
WARNING
Q3： Can the E3600 LFP be used as UPS?
A： E3600 LFP supports UPS function with an automatic switchover time of 8~20ms.
Q4： Can the E3600 LFP be charged while discharging?
A： Yes, E3600 LFP can run devices while it is being charged. The battery will eventually run out if the discharging is
greater than the charging during the pass through charging.
Q5： How to calculate the E3600 LFP running time?
A： Running Time=Total Capacity(3072Wh) * 0.85(Depth of Discharge)/Loading Power(Watts)
Q6： Can I use the E3600 LFP indoors and charge the E3600 LFP indoors?
A： Yes, the E3600 LFP is safe to use indoors.
Q7： Does E3600 LFP have built-in MPPT charge controller?
A： Yes, there are two independent 1200W(PV 32V-150V) MPPT charge controllers inside, and one step up 150W
(PV 12V~30V) MPPT charge controller, The Voc ( Open Circuit Voltage) of the solar panels should not exceed 150V.
Q8： How to store the E3600 LFP?
A： Please turn off the unit and then store it in a dry, ventilated place at normal room temperature. Do not place this
unit near water sources or a wet/moist environment. For long-term storage, it is recommended to discharge the
battery to 30% every three months and recharge it to 60% to sustain the battery life.
To Next Page
Loading...
