Pg. 12 Pg. 13
Operating Procedures
For Trail Tracker
To be able to use the electric motor, the battery
must be mounted by sliding the fully charged
battery forward onto the rear rack, over the
rear wheel, through the channels on the battery
while the carry handle is positioned at the rear.
The key switch position must be in the “unlock”
position to slide the battery on.
UNLOCK OFF ON
The key switch locks the battery in position when the key
is turned clockwise to either OFF or ON.
Plug the power cord into the battery. Turn the key to the “ON” or “OFF” position to
extend the locking mechanism onto the bike to securely fasten the battery onto the
bike. To remove the battery, turn the key to the “UNLOCK” position and pull towards
the rear of the Pedego. Be sure to turn the battery off when not in use so it does not
drain the battery.
To Next Page
Loading...
Need help?
General
