14 15
OPERATING PROCEDURES
For Trail Tracker
Plug the power cord into the battery. Turn the key to the “ON” or “OFF”
position to extend the locking mechanism onto the bike to securely
fasten the battery onto the bike. To remove the battery, turn the key to
the “UNLOCK” position and pull towards the rear of the Pedego. Be sure
to turn the battery off when not in use so it does not drain the battery.
OPERATING PROCEDURES
For Stretch
Lift up the seat by pressing the lever on the rear of the saddle to create
room to insert and remove the battery. Line the grooves on the back of the
battery with the battery holder and insert it fully, then turn the key switch
to the “LOCKED” position to secure the battery in place. The key switch
must be in the unlock position to slide the battery in and out.
The on/off switch is located on the side of battery. After fully inserting
position. Be sure to turn off the power when the Pedego is not in use or is
recharging by clicking the battery switch to the off “O” position.
Operating Procedures Operating Procedures
The battery must be mounted by
sliding the fully charged battery
forward onto the rear rack, over the
rear wheel, through the channels on
the battery while the carry handle is
positioned at the rear. The key switch
position must be in the “unlock”
position to slide the battery on.
FRONT RACK
BACK REST
WHEEL
GUARD
SIDE
PLATFORM
TOP
PLATFORM
Unlock Position Off Position On Position
To Next Page
Loading...
