- 32 -
Now that you have installed the base in
your vehicle, you are ready to install the
car seat on the base.
Holding the car seat by the handle, align
it over the base and press it rear facing on
the base until you hear the click (a). You
will not be able to move the car seat if it is
properly locked in place.
Important! Newborn children should be
properly reclined. If the seat reclines too
much, your baby can be ejected from the
seat in an accident. If too upright, it can
cause breathing problems.
Once the seat is installed on the base with
the child in it, open the rear compartment
and check if the bubble has moved from
the original position. In case re-adjust
the seat until the bubble is in the correct
position.
Installing the Car Seat on the Base
To Next Page
Loading...
