- 39 -
Adjust the chest clip to the arm pit level.
To tighten the harness, pull the adjuster
strap at the bottom of the seat until the
strap is snug. Tuck the loose end of the
adjuster strap under the seat padding.
Pull on straps to make sure that both
plates are latched securely (g).
IMPORTANT NOTE: You may need to
adjust the shoulder height. See how to
raise or lower the shoulder straps at page
42.
Make sure you leave one finger width
between the harness and your
baby’s collar bone or try to pinch the
webbing as shown in the picture (h).
If you can easily pinch the straps the
harness may be tightened further.
How to buckle your baby into the Car Seat
x
To Next Page
Loading...
