30
4. After attaching the
seat, squeeze the front
handle again (fig_a) and,
at the same time, push the
booster seat towards the
vehicle’s seat (fig_b), then
release the handle.
By doing this the release
buttons on the side of
the base will disappear
(fig_c), thus preventing
inadvertent release.
3. IMPORTANT:
The vehicle anchors
and the booster seat
connectors are correctly
coupled when a green
signal appears above the
connectors (fig_a). A red
signal indicates that the
attachments have NOT
been coupled correctly
(fig_b).
Installing the booster seat in the vehicle
To Next Page
Loading...
