13
C
REQUIRED MAINTENANCE
Wheel tires can be replaced if they get worn out or broken.
If it is worn out, the blade will not track straight on the wheels.
To remove the tire from the wheel groove use a flat
screwdriver and install the new tire.
Do not glue the tire on the wheels.
CHANGING SPEED SETTINGS
This machine has 2 different speed settings: 700 MPM /1050 MPM
To change the speed setting:
1. Turn off power and disconnect the saw from the power source.
2. Open the door.
3. At the back of the saw, just above the motor, there is a ratchet
lever to loosen the drive belt, unscrew the bolt a few turns -
counterclockwise then pull up on the capacitor cover of the motor
and pivot the motor to the left. This loosens the belt enough to
move it between one set of pulleys and the other.
4. 700MPM, place the belt on the front most set of pulleys as left
drawing.
5. 1050MPM, place the belt on the rearmost set of pulleys as right
drawing.
6. Having repositioned the belt, push down firmly on the motor
capacitor cover to tighten the belt, turn the ratchet lever clockwise
until it is tight and the motor does not move.
ADJUSTING/REPLACING THE LOWER WHEEL BRUSH
Verify the brush keeps the lower wheel surface clean at all
times, if pitch and sawdust builds up on the lower tire, adjust
or change the brush with use and normal wear over time, the
brush hairs will soften and will not clear the wheel surface as
well, lower the brush or change the slightly.
To Next Page
Loading...