2
INTRODUCTION
Thank you for purchasing model SRP14-CE scroll band saw, this machine has been carefully tested and
inspected before shipment and if properly used and maintained, will provide you with years of reliable service.
VERY IMPORTANT
It is new concept, which you maybe still never seen. We strongly recommend to read carefully and
completely this manual; especially the setting up and the fine-tuning of the blade. A bad adjustment of
guides and blade will make this new concept totally ineffective and cause a premature wear of
elements in movements.
WARRANTY
All components parts of scroll band saw are carefully tested and inspected during all stages of production, and
each unit is thoroughly inspected upon completion of assembly.
Within a period of 2 years from date of purchase, any genuine parts or parts which, upon examination, prove to
be defective in workmanship or material are guarantee to repair or replace.
Along with the return of the product being claimed for warranty, a copy of the original proof of purchase, clearly
stating the model and serial number of the unit and including an explanation of the complaint or presumed
defect in material or workmanship.
WARNING When using electric tools basic safety precautions should always be followed to reduce the
risk of fire, electric shock and personal injury including the following.
Read all these instructions before attempting to operate this product and save these instructions.
Generally, the scroll band saw shall be installed in the following conditions:
1) Supply voltage: 220-240 VAC
2) Source frequency: 50 HZ
3) Ambient temperature: 5°C - 40°C.
4) Relative humidity: not exceed 50% at 40°C.
5) Atmosphere: Free from excessive dust, acid fume, corrosive gases and salt.
6) Avoid exposing to direct sunlight or heat rays which can change the environmental temp.
7) Avoid exposing to abnormal vibration.
8) Electrical equipment shall withstand the effects of transportation and storage temperature within
a range of -25°C to 55°C and for short periods not exceeding 24 hours at up to +70°C.
SAFETY RULES
1 - Keep work area clear
- Cluttered areas and benches invite injuries.
2 - Consider work area environment
- Do not expose tools to rain.
- Do not use tools in damp or wet locations.
- Keep work area well lit.
- Do not use tools in the presence of flammable liquids or gases.
3 - Guard against electric shock
- Avoid body contact with earthed or grounded surfaces
4 - Keep other persons away
To Next Page
Loading...