12
Warning that in case of loss of power supply, the braking function is not operating, and it is necessary to
wait for the complete standstill of the machine before opening the doors. In case of broken band or belt if fitted,
the wheels may keep running, and it is necessary to wait for the complete standstill of the machine before opening
the doors.
POWER ON/OFF SWITCH
Plug the power cable into a correctly rated switch socket outlet. If
extension leads are being used, check these and make sure that they are
not damaged.
This scroll band saw is equipped with a magnetic ON/OFF switch (A)
To START the saw: Press the green button “I”.
To STOP the saw: Press the red button “O”.
Whenever the saw is not in use, insure the saw is switch OFF by pressing
the red button “O”
A
C
LED work light
High quality LED work light is installed on saw itself.
LED ON/OFF switch B is on the arm with light mark.
Fuse
This saw takes 2 fuses.
Fuse C 10 AMP for protecting machine electricity.
Fuse D 1 AMP for protecting LED light.
Protection
When this saw is pressed OFF from the power, the saw
blade and wheels will stop running within 10 seconds to
avoid any accidental injury from the running parts.
(CE regulation)
B
D
SAFETY DEVICES
The saw is equipped with a safety switch system, which quickly interrupts the machine if the doors are
opened during operation. The machine will restart when the doors are in closed position and the green
button pressed again.
WARNING: the pin of breaker is exposed, pay attention in the pin to avoid injury.
To Next Page
Loading...