4
- Before further use of tool, it should be carefully checked to determine that it will operate properly
and perform its intended function.
- Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and
any other conditions that may affect its operation.
- A guard or other part that is damaged should be properly repaired or replaced by an authorized
service centre unless otherwise indicated in this instruction manual.
- Have defective switches replaced by an authorized service centre.
- Do not use the tool if the switch does not turn it on and off.
21 - Warning
- The use of any accessory or attachment other than one recommended in this instruction manual
may present a risk of personal injury.
22 - Have your tool repaired by a qualified person
- This electric tool complies with the relevant safety rules. Repairs should only be carried out by
qualified persons using original spare parts, otherwise this may result in considerable danger to
the user.
The figures quoted are emission levels and are not necessarily safe working levels. Whilst there is a
correlation between the emission and exposure levels, this cannot be used reliably to determine whether or not
further precautions are required. Factors that influence the actual level of exposure of the workforce include
the characteristics of the work room and the other sources of noise, etc., i.e. the number of machines and other
adjacent processes. Also the permissible exposure level can vary from country to country. This information,
however, will enable the user of the machine to make a better evaluation of the hazard and risk.
Test under no load
A-weighted sound power level
L
WA
= 78 dB Uncertainty K
WA
= 4 dB
Test under load
A-weighted sound power level
L
WA
= 90 dB Uncertainty K
WA
= 4 dB
WARNING The symbols below advise that you follow the correct safety procedures when using this machine.
Keep away your fingers from the saw blade
Keep away your fingers from the blade wheel
Dust mask should be worn
Eye protection should be worn
Ear protection should be worn
Disconnect from power supply before servicing
Fully read manual and safety instructions
before use
î
Safety gloves should be worn
To Next Page
Loading...