What to do if Pairing failed on my Pelgrim GVWC270L Dishwasher?
If pairing failed on your Pelgrim dishwasher, check that the router is connected to the internet. Check that your smartphone/tablet is connected to your wireless network.
What to do if water remains in my Pelgrim GVWC270L?
If water remains in your Pelgrim dishwasher, start by cleaning the coarse and fine filters. Also, check that the filters are fitted correctly. Inspect the drainage pump for any debris and clean it if necessary. Ensure the yellow drainage pump stop is in place. Check the drainage hose for kinks or sharp bends. Finally, disconnect the drainage hose from the sink unit's water trap to check for blockages, ensuring the connection has an inner diameter of at least 14 mm.
Why won't my Pelgrim GVWC270L door close?
If you cannot close the door of your Pelgrim dishwasher, ensure that the baskets are correctly positioned horizontally and that dishes are not blocking the baskets from sliding properly into place. If the door lock does not click into place, open the door, press and hold Automatic door opening until the display counts down, wait until the countdown ends (60 seconds), then close the door and check that the door lock clicks into place.
Why is my Pelgrim GVWC270L Dishwasher shown as disconnected in the ConnectLife app?
If your Pelgrim dishwasher is shown as disconnected in the ConnectLife app, the WiFi connection is deactivated. Activate the WiFi connection.
How to fix a Pelgrim GVWC270L Dishwasher that cannot close?
Make sure the baskets are correctly positioned horizontally. Also, check the door lock. If it doesn't click into place, open the door, press and hold Automatic door opening until the display starts counting down, wait until the countdown ends (60 seconds), then close the door and ensure the lock clicks into place.
What to do if the water softener is leaking salt in my Pelgrim Dishwasher?
Check that the salt compartment lid is properly tightened.
How to fix F10 error on Pelgrim GVWC270L Dishwasher?
To fix the F10 error on your Pelgrim dishwasher, unblock the drainage pump.
What to do if my Pelgrim GVWC270L Dishwasher control panel does not react?
If the control panel isn't responding, you might have pressed it too soon after opening the door; wait a moment and try again. Ensure the door is open, as the control panel only works when the door is open. Also, check for dirt on the control panel and clean it with a dry or slightly damp cloth.
Why does my Pelgrim GVWC270L have grease deposits?
Grease deposits in your Pelgrim dishwasher are often caused by prolonged use of low temperature programs. Select a program with a high temperature to dissolve grease on very dirty dishes, such as Intensive 70°.
Why does my Pelgrim GVWC270L have spots on stainless steel or silver?
Spots on stainless steel can be caused by some foodstuffs, such as mustard, mayonnaise, lemon, vinegar, salt and dressings, if left for too long. Rinse off these types of foodstuffs if not starting the dishwasher immediately. Consider using 1h 65° with the Speed wash option. All stainless steel can cause spots on silver if they come into contact during dishwashing. Aluminium can also cause spots on dishes. Separate dishes made from different metals, such as silver, stainless steel and aluminium, to avoid marks and tarnishing.
General| Type | Freestanding |
|---|---|
| Noise level | 49 dB |
| Drying Class | A |
| Width | 60 cm |
| Height | 85 cm |
| Depth | 60 cm |
To Next Page
