ADJUSTING THE WORKING POSITION
• Unlock the front handle adjuster knob.
Adjusting the position of the front handle adjusts the grass cutting brush-cutter's "horizontal position", so
that it is within reach and the cutting head makes slight contact with the ground. The elbow should not be
bent.
(This adjustment is performed at the same time as the adjustment of the harness length.)
ADJUSTING THE POSITION OF THE FRONT HANDLE
Before every use, the Excelion 1200 grass cutting brush-cutter's working position must be adjusted
according to the size of the operator. This enables operating comfort requiring little effort from the operator.
Adjusting the machine's working position according to the size of the operator consists in four steps:
- adjustment of the front handle position,
- installation of the harness and adjustment of its length,
- adjustment of the tube length,
- adjustment of the cutting head orientation.
These various adjustments are repeated until the brush cutter is in an adequate working position.
These various adjustments are repeated until the brush cutter and grass trimmer is in a suitable working
position.
• Slide the front handle along the telescopic tube until it
is a suitable position.
• Lock the front handle adjuster knob to block the
handle's position on the machine.
ADJUSTING THE WORKING POSITION
To Next Page
Loading...
