ADJUSTING THE WORKING POSITION
Adjusting the length of the telescopic tube enables the correct swing radius to be obtained according to the
size of the operator or the working environment.
ADJUSTING THE LENGTH OF THE TELESCOPIC TUBE
• Unlock the locking grip by turning it counter-clockwise.
• Adjust to the desired telescopic tube length.
• Lock the locking grip.
Adjusting the cutting head orientation enables the cutting head to be aligned with the ground. The cutting
head should touch the ground slightly.
ADJUSTING THE CUTTING HEAD ORIENTATION
• Unlock the motor casing knob.
• Adjust the cutting head so that it is parallel with the
ground.
• Lock the motor casing knob to block the cutting head
in position.
Cutting head adjustment
range
To Next Page
